Summary: Target of rapamycin complex 1 (TORC1) is a master regulator that monitors the availability of various amino acids to promote cell growth in Saccharomyces cerevisiae.It is activated via two distinct upstream pathways: Motion Sensor the Gtr pathway, which corresponds to mammalian Rag, and the Pib2 pathway.This study shows that Ser3 was phosp
Thermal Stability and Compression Strength of Rigid Polyurethane/Kenaf Fibre Biocomposite Foam
Rigid palm oil-based polyurethane/kenaf fibre biocomposite foams were prepared at various amounts of kenaf fibre (i.e.2.5, 5.0, 7.5, 10.0 and 12.5 pphp).Effects of kenaf fibre (KF) loadings on thermal stabilities and compressive strength were investigated.The peaks detected by Fourier transform Unisex Perfume infrared (FTIR) at 3,310 cm-1 (OH stret
Temporomandibular joint dislocation after long-term mechanical ventilation
Introduction: Dislocations of the temporomandibular joints (TMJ) are relatively common and occur in as many as 7% of S.O.D. the entire population at some point in their lives.Anterior dislocations are the most common and are defined as the excessive forward movement of the mandibular condyle out of the glenoid fossa beyond the articular eminence wi
Lung ultrasound in a tertiary intensive care unit population: a diagnostic accuracy study
Abstract Background Evidence from previous studies comparing lung ultrasound to thoracic computed tomography (CT) in intensive care unit (ICU) patients is limited due to multiple methodologic weaknesses.While addressing methodologic weaknesses of previous studies, the primary aim of this study is to Chair Accessories investigate the diagnostic accu
Comparative Study of 2060-T8 Al-Li Alloy Friction Stir Welded Joints Between Natural Cooling and Water Cooling
2060-T8 Al-Li alloy was friction stir butt welded under natural and water cooling conditions.Microstructures and mechanical properties of the welding joints were mainly compared and discussed.By spraying water on ORG SAFARI MIX the top surface of stir zone, the grain size was reduced, attributing to the improvement of microhardness.The maximum tens